Power Fist 8866659 Mode D'emploi page 11

V1.0 9 Gallon Twin-Tank Wheelbarrow Portable Air Compressor
START/STOP
1. Connect the air line to the quick coupler.
2. To adjust the amount of air pressure supplied:
a. Pull up on the regulator knob (M) to unlock it.
b. The regulator pressure gauge (I) displays the current line pressure.
Turn the knob clockwise to increase pressure and
counterclockwise to decrease pressure.
c. Push the knob down to lock it into position.
3. Ensure the drain valve on each tank (K and L) is closed by rotating
them to the left.
4. Open the petcock on the unloader valve for cold starts (turn clockwise
or in).
5. Flip the toggle on the pilot valve to the vertical position.
6. Start the gas engine (consult the gas engine manual).
7. Watch and listen for excessive vibration and unusual noises. If either
exist, stop the compressor and refer to Troubleshooting.
8. Allow the compressor to run for a few minutes.
9. Close the petcock (turn counterclockwise).
10. Flip the toggle on the pilot valve to the 'RUN' position. The compressor
should pump up the tank to 135 PSI, then unload. If pressure exceeds
135 PSI, see Troubleshooting.
11. To stop the compressor, shut the engine off.
USING THE COMPRESSOR
WARNING! Always ensure the regulator pressure gauge reads zero before
changing air tools or disconnecting the hose from the air outlet. Failure to
do so could result in possible serious personal injury. Run the tool to
depressurize the system.
Your tool may require more air consumption than this air compressor is
capable of providing. Check the tool manual to avoid damage to the tool or
risk of personal injury.
Always use the minimum amount of pressure necessary for your
application. Using a higher pressure than needed will drain air from the tank
more rapidly and cause the unit to cycle on more frequently.
Visit www.princessauto.com for more information
8866659
11