Usb Interface Installation; Usb 2.0 Interface Installation - Archos Slim CDRW Guide D'installation

All manuals and user guides at all-guides.com
Windows 2000, Windows XP:
•
Turn on your computer and wait for Windows to finish booting.
•
Insert PCMCIA card (Archos logo face up) into an open PCMCIA slot in your
computer.
Follow steps listed below to complete installation:
Found new hardware wizard will pop up. System will install
1.
ARC ATAPI,
PCMCIA IDE/ATAPI Controller,
ARCHOS SlimCDRW and
CD-ROM Drive using standard Windows drivers.
No driver files will be needed from Archos.
You must restart your computer before the new settings will take effect.
2.
B. USB Interface Installation
Windows 98SE - Windows ME & Windows 2000
•
Turn on your system and wait for Windows to finish booting.
•
Insert the driver floppy disk .
•
Insert USB cable to an open USB port on your computer. Follow steps listed below
to complete installation:
•
A "New Hardware Found" window will guide you through installation of driver.
When prompted for driver disk, Check "Floppy disk drives" box, and uncheck all
other boxes. Insert Install Disk in floppy drive then click Next.
C. USB 2.0 Interface Installation
Note – using USB ports repeated on some peripherals (such as keyboards)
may cause quick discharge.
Windows 98SE:
•
Turn on your computer and wait until it has finished booting.
•
Connect USB end of USB cable to a free USB port on your computer
•
A "New Hardware Found" window will guide you through installation of driver.
When prompted for driver disk, Check "Floppy disk drives" box, and uncheck all
other boxes. Insert Install Disk in floppy drive then click Next.
7