System Menu (System); Nap Timer (Nap Function); Setting The Nap Timer - SilverCrest SRH 5 B2 Mode D'emploi Et Consignes De Sécurité

System menu (System)

NOTE
► The system menu can be called up during operation and also in standby
mode .
► If no setting is made in the system menu within 20 seconds, the device exits
the settings menu .
♦ Press the INFO/MENU button
♦ Press the TUNE+
turn the VOLUME |
the display
♦ Press the VOLUME |

Nap timer (NAP function)

Using the NAP function, you can set a timer alarm that will wake you up with an
alarm signal after 1–120 minutes .

Setting the nap timer

♦ Call up the system menu . The first menu item to appear is the NAP timer .
♦ Press the VOLUME |
♦ Press the TUNE+
between 001 and 120 minutes .
♦ Press the VOLUME |
and start the nap timer . After exiting the system menu, N appears on the
display
♦ When the nap time has elapsed, an increasingly loud alarm sounds .
NAP flashes on the display
Deactivating the nap timer
♦ When the alarm goes off, press any button to end the timer .
NOTE
► To turn off the timer before the end of the alarm time, call up the NAP func-
tion as described in the section Setting the nap timer . Set the alarm time
to 000 and press the VOLUME |
the selection . The nap timer is now deactivated .
■ 56 GB │ IE
│
or TUNE−
8
ENTER / SCAN dial
.
1
ENTER / SCAN dial
ENTER / SCAN dial
or the TUNE− button
8
ENTER / SCAN dial
ENTER / SCAN dial
followed by the remaining minutes or seconds .
1
1
for approx . 2 seconds .
4
button (several times if necessary) or
7
6
6
6
or turn the VOLUME |
7
to set the alarm time in 1-minute steps
6
6
and the set alarm time is displayed .
ENTER / SCAN dial
until System appears on
to confirm the selection .
to confirm the selection .
to confirm the selection
to confirm
6
SRH 5 B2