Connecting The Sensor Or Sensors To The Measuring Instrument And Starting Up - WEBTEC SR-PTT CAN Serie Mode D'emploi

3.3 Connecting the sensor or sensors to the measuring instru-
ment and starting up
Using a connection cable, the individual sensor or sensor bus system
should be connected to one of the CAN ports on the measuring instru-
ment.
After the measuring instrument is turned on, the sensor is automatically
detected and initialized. The start screen appears on the display after this
process has ended. The LED signals on the CAN sensors are used for
identification and status display.
► Additional information about the LED signals can be found in the
"LED signals on the sensor" table.
After the boot-up process, you can make further setting changes on the
measuring instrument or you can begin measuring.
► Additional information about operating the measuring instrument can
be found in the instrument's operating instructions.
31