ChefLine CHPO000PC Mode D'emploi page 16

display surface, the shelves, the glasses with specific cleaners for
any surface.
Do not use acid and alkaline detergents, chemical / organic
solvents, unknown chemical composition detergents.
During the maintenance and cleaning it is forbidden to use
abrasive substances and/or sharp tools which can damage
the unit.
After every cleaning operation it is necessary to rinse with warm
water and dry the unit with a soft and clean cloth. Clean the
condenser, after having removed the cover grid, with a dry paint
brush (do not use iron brushes) or a vacuum cleaner, removing all
dust and possible deposits on the fins.
During the maintenance and cleaning pay attention not to
bend or damage the fins and the whole refrigerating unit.
Never neglect this operation, as it is basic for the good working
of the unit and to avoid possible breakings. When you have
finished this operation, fit the cover grid in its original position.
When the cleaning operation is over, make sure that
everything is clean and dry before connecting the equipment to
the power supply again. When the unit reaches the correct
working temperature, it is possible to reload it. In case of long
absences (i.e. holidays etc.) the unit has to be unplugged,
emptied completely, cleaned and dried to prevent bad smells.
A correct maintenance of the equipment can considerably prolong
its life.
19.
19. TECHNICAL ASSISTANCE - servicing
If the equipment does not run properly or does not work at
all, in your own interest before calling for servicing, we
suggest to check the following points:
- if the plug is well inserted in the socket;
- if the power reaches the socket to which the equipment is
connected;
- if the thermostat is set as recommended;
- if the network voltage is the same as requested for the
equipment (+-6%);
- if the evaporator is covered with ice (in this case
proceed as indicated at paragraph 16);
- if the condenser is clean (paragraph 18);
- if there are air draughts, if the cabinet is installed in the
correct position (see paragraph 9) and if the ambient
temperature is as indicated (see paragraph 7).
20. REPLACEMENT OF LED CEILING LAMP
The replacement and the substitution of led ceiling lamp must
be made by qualified technician and when the unit is
disconnected from the power net.
Before replacing the ed ceiling lamp disconnect the
equipment by the general power supply. During the whole
replacement operation use proper working gloves.
21. EMERGENCY SITUATIONS
Devices to be used in case of fire: powder-extinguishers or
liquid-extinguishers complying with the current legislation.
22. DISMANTLING THE UNIT
The unit must be disposed of in accordance with your
country's waste management legislation.
IN CASE OF REQUEST FOR SERVICE, CONTROL AND/OR
REPLACEMENTS YOU WILL HAVE
TO CONTACT THE SUPPLIER WHERE THE CABINET WAS
BOUGHT.
23 . ATTACHMENTS
1. EC declaration of conformity
2. Thermostat instructions.
3. Assembly instructions
17