EarthQuake Victory 39381 Manuel De L'utilisateur page 18

CHECK TILLER TRANSMISSION GREASE
Check the grease level annually. To check the grease level:
1. Tiller must first be run for approximately 30 minutes to
warm up grease for a proper measurement. Once warm let
sit 5 minutes to allow grease to settle.
2. Move tiller to level ground, making sure the transmission
cover plate is level.
3. Remove the gear case dipstick located between the
handle bar mounts and the engine mount and wipe
grease off dipstick. SEE FIGURE 12.
4. Reinsert the dipstick all the way into the hole port in the
transmission cover plate. SEE FIGURE 13.
5. Remove the dipstick and check grease level. If level is
in the bottom ADD area or not present, add grease in
200ml increments until grease level reaches a proper level
reading. DO NOT OVERFILL. The slashed, acceptable
grease level area on the dipstick has a 200ml range.
NOTE: The front wheel transmission and rear tine
transmission share a common reservoir. Recommended
grease is Mystic 00, or equivalent, transmission grease.
Oil must have an API - E.P (extreme pressure) rating of
GL4 or lower. Higher E.P. rating (ie - GL5, GL6 etc) will
cause the bronze components to soften. For partial fill-ups
(a few ozs or less) use SAE 140W or 85W gear oil or SAE
80W-90 weight gear oil with a API rating of GL4 or GL5.
When replacing grease, the tiller transmission holds 18-
22 ounces. DO NOT OVERFILL.
18 Get parts online at www.getearthquake.com or Call 800-345-6007 M-F 8-4:30 CST
CAUTION
DO NOT PUT
ENGINE OIL IN
TRANSMISSION.
LUBRICANT IS
I N S TA L L E D BY
MANUFACTURER.
GEAR CASE
DIPSTICK
TRANSMISSION
COVER PLATE
Operator Manual
VICTORY REAR TINE TILLER
GEAR CASE
DIPSTICK
FIGURE 12
ACCEPTABLE GREASE LEVEL
ADD GREASE
FIGURE 13