EarthQuake Victory 39381 Manuel De L'utilisateur page 13

To adjust tilling depth do as follows:
1. Remove lock pin.
2. Raise the drag stake to position tines at chosen tilling
depth. Raising the drag stake will allow for deeper tilling.
3. Align hole in drag stake with hole in drag stake mount and
replace lock pin.
WHEEL LOCK PINS
To place wheels in free-wheel position do as follows:
NOTE: This allows wheels to turn freely on the axle for easy
transportation.
1. Remove lockpin. Slide wheel inward toward unit.
SEE FIGURE 8.
2. Insert lockpin through the axle hole only, fold lock ring to
secure pin to axle.
3. Repeat for other wheel.
To place wheels in tilling position do as follows:
NOTE: This locks wheels to the axle so they are able to propel
the unit forward while in use.
1. Remove lockpin. Slide wheel slightly outward away from
unit. Align hole in axle with hole in wheel hub.
SEE FIGURE 9.
2. Insert lockpin through both holes, fold lockpin ring to
secure pin to axle.
3. Repeat for other wheel.
NOTE: Do not operate tiller with only one wheel locked.
Get parts online at www.getearthquake.com or Call 800-345-6007 M-F 8-4:30 CST
LOWER JAM NUT
REVERSE CABLE
WARNING
EXTREME CAUTION MUST BE TAKEN IN SELECTING TILLING
DEPTH. IF YOU ATTEMPT TO TILL TOO DEEPLY FOR SOIL
CONDITIONS, THAT IS, WITH THE DRAG STAKE IN TOO
HIGH OF A POSITION, LOSS OF CONTROL AND INJURY TO
PERSONNEL CAN OCCUR.
|ALWAYS SET THE DRAG STAKE LEVER IN THE TRANSPORT
POSITION BEFORE STARTING THE ENGINE. PLACE THE
LOCKPIN IN THE HIGHEST HOLE OF THE DRAG STAKE.
DRAG STAKE
Operator Manual
VICTORY REAR TINE TILLER
SPRING STRETCH
WHEN ENGAGED
1/4"
UPPER JAM NUT
FORWARD CABLE
FIGURE 6
LOCKPIN
DRAG STAKE
BRACKET
Transport hole
Shallow Digging
Deepest Digging
FIGURE 7
13