inventiv 202101 Instructions D'origine page 26

13. USING THE LASER GUIDE (SEE FIG. K)
Never stare directly into the laser beam and never point the beam at anybody. The laser beam
energy is extremely harmful to your eyes.
1. The laser generator is for the purpose of precision cutting, and projects a visible red line on the
workpiece surface, make your mitre cut along the red line.
2. To use the laser generator, simply press the laser guide on/off switch (4), the laser generator
then projects a visible red line on the workpiece surface, make your mitre cut along the red line.
To turn off the laser, press the switch again.
14. WORK LIGHT
Press the on/off switch, the work light will illuminate.
Release the on/off switch to turn off the work light.
CAUTION: Do not look into the strong light or see the source of light directly.
202101 750W JIG SAW WITH LASER GUIDE
10. DUST TUBE (SEE FIG. I)
I
Mount the dust tube (6) into the opening of the base
plate. Make sure that the plastic tip of the vacuum
connection engages into the corresponding opening on
the housing as shown in the figure
11 DUST-BLOWING SWITCH (SEE FIG. J)
J
Slide the dust-blowing switch to back to the position for
blowing dust and splinters in the area which has been cut.
Slide the dust-blowing switch to forward to the position
when you are connected to a powder or a vacuum
extraction system domestic.
12. FINGER PROTECTION
The finger protection is located in front of the blade
holder. Whilst working, it will help prevent accidental
contact with moving blade.
NOTE: The saw dust may block the laser beam, clean
K
the laser generator Periodically.
Switch off the laser when you stop the machine. The
laser does not switch off automatically.
SAFETY AND OPERATING MANUAL
26