inventiv 202101 Instructions D'origine page 25

7. PENDULUM ACTION CONTROL (See Fig. G)
The pendulum action varies the forward cutting angle
of the blade for increased cutting efficiency. This can
also be adjusted during no load running. Refer to the
chart 2 for more details. Do not use excessive blade
force when cutting with the pendulum action. The blade
cuts on the upward stroke only.
Chart 2
0 Thin materials. Fine cuts. Tight curves.
I Hard materials, (e.g. steel & chipboard)
II Thick materials ( e.g. wood ) & plastic
Fast cuts (e.g. softwood). Cutting in the
III
direction of the wood grain.
8. BASE PLATE
Adjusting the angle of the base plate enables bevel
cutting. The base plate must always be held firmly
against the materials being cut to reduce saw vibration,
blade jumping or blade breakage.
9. BASE PLATE ANGLE ADJUSTMENT (See Fig. H1, H2)
Your jig saw is equipped the SDS base plate. Hold the SDS spanner and turn it 90. For preset
angles rotate so the lines of the angle on the base plate and angle plate superposition at the
desired angle (0°, 15°, 30°, 45°). For other mitre angles, rotate to your desired angle (use a
protractor scale). Following one of the above procedures, hold the base plate in position and
return the SDS spanner to clamp the base plate at that angle. Finally, check the angle and
ensure the base plate is firmly clamped. The angle markings on the base plate are accurate
for most general purposes but it is recommended for accurate work to set the angle with a
protractor and make a test cut on other material.
202101 750W JIG SAW WITH LASER GUIDE
H1
19
SAFETY AND OPERATING MANUAL
25
F2
G
H2