inventiv 202101 Instructions D'origine page 24

Chart 1
Material
Wood
Metal
Aluminum
PVC
Ceramic
202101 750W JIG SAW WITH LASER GUIDE
4. BLADE FITTING (See Fig. D)
D
NOTE: Remove the plug from the socket before
carrying out any adjustment, servicing or maintenance.
18
Press the edge of blade holder firmly (Jigsaw upside
down) and hold in position. Then fully insert the blade
into the blade holder slot with blade teeth facing
forward and release the blade holder, which will clamp
over the top of the blade. Try to pull the blade out of
the blade holder again to ensure it is locked in position.
Ensure the edge of the blade is located in the groove
of the blade guide. To remove a blade, press the blade
holder and then lift out the blade.
cutting results ensure you use a blade suited to the
material and cut quality you need.
5. ROLLER GUIDE (See Fig E)
E
Ensure the blade is located and runs smoothly in the
groove otherwise the pendulum function will not work
correctly and the blade will not be supported during
cutting.
6. MOUNTING PARALLEL GUIDE (See Fig. F1, F2)
F1
Slide the parallel guide arm through both parallel guide
fixtures and tighten the locking nut to achieve the
required cutting distance. The parallel guide can be
mounted in two positions as shown below.
SAFETY AND OPERATING MANUAL
Speed setting
5-6
3-4
3-5
3-4
3-5
WARNING: blade teeth are very sharp. For best
24