Publicité
Les langues disponibles
Les langues disponibles
sheet steel or similar is not suitable for laser applications as the reflective surface may
direct the laser beam back at the operator.
5. Do not change the laser device with a different type. The manufacturer or an authorized
agent must carry out repairs.
6. CAUTION: Use of controls or adjustments other than those specified herein may result
in hazardous radiation exposure.
Additional safety warning for class 2 laser
The laser device fitted to this tool is CLASS 2 with a maximum radiation of XXXmW and XXXnm
wavelength.
CLASS 2 LASER RADIATION, DO NOT STARE INTO BEAM
6. OPERATING INSTRUCTIONS
Note: Before using the tool, read the instruction
book carefully.
Intended Use
The machine is intended for sawing wood, plastic,
metal and building materials while resting firmly
on the workpiece. It is suitable for straight and
curved cuts with bevel angles to 45°. The saw blade
recommendations are to be observed.
1.ON/OFF SWITCH (See Fig. A)
Depress to start and release to stop your tool.
2. SWITCH LOCK-ON BUTTON (See Fig. B)
Depress on/off switch then lock-on button, release on/
off switch first then lock-on button second. Your switch
is now locked on for continuous use. To switch off your
tool just depress and release on/off switch.
3. VARIABLE SPEED CONTROL (See Fig. C)
Adjust the thumb-wheel to increase or decrease the
speed according to the material, material thickness and
blade specification to be used (also possible during no
load operation). See Chart 1 for general guidance on
speed selection.
Avoid prolonged use at very low speed as this may
damage your jigsaw's motor.
202101 750W JIG SAW WITH LASER GUIDE
SAFETY AND OPERATING MANUAL
23
A
B
C
Publicité
