Operation
• Connect the power plug to a suitable electrical
power outlet.
• Place the sliced bread into the tong and place the
tong into the bread insert.
• Turn on the appliance by rotating one of the timer
knobs clock-wise to the desired time span (0 – 8
min). The orange power indicator light will turn
on.
• Once the desired time has been reached, the
appliance will alarm beep sound and the power
indicator light will turn off.
Cleaning and Maintenance
Attention: Always unplug the appliance from the electrical power outlet and let it cool down completely before
cleaning and storage.
• Clean the appliance regularly and any food resi-
dues removed.
• CAUTION! Never use any abrasive or hard objects
for cleaning.
Parts
EN
All accessories such
as tongs, etc.
External surfaces
Storage
• Always make sure the appliance has already
been disconnected from the electrical power out-
let and cool down completely.
Troubleshooting
If the appliance does function properly, please check the below table for the solution. If you are still unable to
solve the problem, please contact the supplier/service provider.
Problems
The appliance is connected to
the power supply and rotated the
timer knob but the power indica-
tor does not light up.
The appliance does not heat up
but the heating indicator light up.
6
How to clean
- Soak in warm, soapy water for about 10 to 20 minutes.
- Rinse under running water thoroughly.
- Wipe clean with a soft cloth and a little mild detergent.
Make sure no water or moisture enters inside the of
the appliance.
Possible causes
Power plug is not connected
properly to the electrical power
supply outlet.
Heating indicator defective.
Temperature dial defective.
Heating element defective.
• Crumbs which fall down during the process will
be stored in the crumb tray.
• Unplug the appliance from the electrical power
outlet.
• Allow the appliance to cool down completely be-
fore cleaning or storage.
Note: Due to manufacturing residues, the appli-
ance may emit a slight odor. This is normal and
does not indicate any defect or hazard. Make sure
the appliance is well ventilated.
• Clean the appliance with luke-warm water and
a soft cloth.
• Do not use water jet or steam cleaner for clean-
ing and do not push under the water.
• No any parts can be cleaned in the dishwasher.
• Store the appliance in a cool, clean place.
Possible solutions
Check again to make sure it is
connected properly.
Contact the supplier.
Contact the supplier.
Contact the supplier.
Remark
Dry all parts well at
last.