Before the appliance is used, it must be properly positioned and installed as described
in this manual, so read the manual carefully. To reduce the risk of fire, electric shock
or injury when using the appliance, follow basic precautions, including the following:
Plug into a grounded 3-holed outlet, do not remove the grounding prong, do not use an adaptor, and do
•
not use an extension cord.
Replace all panels before operating.
•
It is recommended that a separate circuit be provided exclusively for your appliance. Use receptacles
•
that cannot be turned off by a switch or a pull chain.
Never clean appliance parts with flammable fluids. The fumes can create a fire hazard or explosion. Do
•
not store or use gasoline or other flammable vapours and liquids in the vicinity of this or any other
appliance. The fumes can create a fire hazard or explosion.
Before proceeding with cleaning and maintenance operations, make sure the power cord of the unit is
•
disconnected.
Do not connect or disconnect the electric plug when your hands are wet.
•
Unplug the appliance or disconnect the power before cleaning or servicing. Failure to do so can result in
•
electric shock or death.
Do not attempt to repair or replace any part of your appliance unless it is specifically recommended in
•
this material. All other servicing should be referred to a qualified technician.
FOLLOW WARNING INSTRUCTIONS BELOW ONLY WHEN APPLICABLE TO YOUR MODEL:
Use two or more people to move and install the appliance. Failure to do so can result in injury to the
•
back or other areas.
To ensure proper ventilation for your appliance, the front of the unit must be completely unobstructed.
•
Choose a well-ventilated area, with temperatures above 60° F (16° C) and below 90° F (32° C). This unit
must be installed in an area that is protected from the elements, such as wind, rain, water spray, or drips.
The appliance should not be located next to ovens, grills, or other sources of extreme heat.
•
The appliance must be installed with all electrical, water, and drain connections in compliance with local
•
regulations. A standard electrical supply (115 V AC, 60 Hz only) is required, properly grounded in
compliance with local regulations and ordinances.
Do not kink or pinch the power supply cord of the appliance.
•
The fuse (or circuit breaker) size should be 15 A.
•
It is important for the appliance to be levelled in order to work properly. You may need to make several
•
adjustments in order to level it.
All installation must be in compliance with local plumbing code requirements.
•
Verify that the pipes are not pinched, kinked, or damaged during installation.
•
Check for leaks after connection.
•
Never allow children to operate, play with, or crawl inside the appliance.
•
Do not use solvent-based cleaning agents of abrasives on the interior. These cleaners may damage or
•
discolour the interior.
Do not use this apparatus for any purpose other than its intended purpose.
•
IMPORTANT SAFETY GUIDELINES
17