Getting Started - Waterpik WF-03 Mode D'emploi

1
1
Inserting Batteries
1
1
Remove water reservoir.
2
2
2
Twist battery door left from
2
the locked position to unlocked
position and pull battery door
away from the unit.
3
3
Insert 3 AA batteries
3
as shown.
3
4
To replace battery door,
4
line-up arrows, push
4 and twist.
4
Replace batteries when there is a noticeable change in performance.
Filling the Reservoir
Lift the flip top on reservoir and fill the
reservoir with lukewarm water.
Inserting and Removing Tips
Insert tip into the center of the knob at the top
of the Water Flosser handle. The colored ring will be flush with the end of
the knob if the tip is correctly locked into place. To remove the tip from the
handle, press the tip eject button and pull tip from handle.
Adjusting the Pressure Setting
You can adjust the pressure setting on your Water
Flosser by simply sliding the pressure/power switch
on the handle. Slide power switch up 1 click for low
(l) pressure and 2 clicks for high (ll) pressure.
Recommended Technique
Lean low over sink and place the tip in mouth.
Aim the tip toward teeth, and turn the unit ON (l).
For best results, start with the back teeth and
work toward the front teeth. Glide tip along gumline and pause briefly
between teeth. Continue until you have cleaned the inside and outside of
both the upper and lower teeth.
Direct the jet stream at a 90-degree angle to your gumline. Slightly
close lips to avoid splashing but allow water to flow freely from mouth
into the sink. Keep unit upright during use for best results.
When Finished
Turn the unit off. Empty any liquid left in the reservoir.
If desired, the reservoir may be removed from the power handle by sliding
the reservoir down towards the base of the unit.
To replace the reservoir on the power handle, simply slide it up towards the
top of the unit.
7

GETTING STARTED

Pressure
Setting