BEFORE FIRST USE
•
Remove packaging materials such as cardboard, plastics or
styrofoam and discard appropriately.
•
Wipe clean all the parts with a soft damp cloth or sponge and dry
thoroughly.
•
DO NOT immerse in water or place in dishwasher.
•
The GASKET sets in behind the wire guide. Before your first use,
gently pull the GASKET out. (IMAGE 1)
•
Hand wash in warm soapy water. Dry, then firmly press the
GASKET back in behind the wire guide. Make sure GASKET is
properly installed in groove inside the LID. (IMAGE 2)
HOW TO OPEN THE LID
When the LID of the cooker is at the "Closed-Lid Position", hold the LID
HANDLE and turn it about 1/8 of a turn clockwise (IMAGE 3), until you
reach the "Open-Lid Position". Lift up on the LID HANDLE.
NOTE: For brand new units, the seal of the LID may be slightly stronger
than normal and may be slightly difficult to unlock. Once the LID has
been opened and closed several times, it will loosen up.
HOW TO CLOSE THE LID
When the LID of the cooker is in vertical position hold the handle and close it downwards
at the "Open-Lid Position". After that, turn it in a counter clockwise direction until you
reach the "Closed-Lid Position".
HOW TO DISMANTLE THE LID
When the LID of the cooker is in the upright vertical position, hold the LID with both
hands, and adjust the height between the LID and the upper edge of the cooker to
around 4 inches (IMAGE 4). Then turn it in a counter clockwise direction until you reach
the "Closed-Lid Position" (IMAGE 5). Then lift the LID up and away from the SMART
CANNER body (IMAGE 6).
4.
WARNING - Hot steam will periodically be
released out of the STEAM RELEASE VENT. Be sure
nothing is directly above this area when using the
"Smart Canner".
BEFORE FIRST USE
5.
6.
3
1.
2.
3.