Publicité
Les langues disponibles
Les langues disponibles
Changing the calibration of the temperature detection probe
If the location of the device does not permit suitable detection of the temperature, it is possible to change
the temperature detected by ±3 °C with increases of a tenth of a degree.
The first number flashes E; use the
arrows
to enter the first digit of the
code, and the
next digit; pressing button
means the code entered is considered valid
and you move on to the next parameter to
be configured.
E
Use the
detected by the desired value and press the
button to move on to the next parameter
to be configured.
F
Setting the type of heat
management algorithm
The device lets you choose the type of
algorithm to apply for the management of
the system between:
• Differential
• Proportional Integral
G
Differential Algorithm G
If, on screen G, using the
differential algorithm type has been chosen,
press the
button to customise the value
of the differential, using the
Note. The range of adjustment goes from
0 to 1°C.
H
arrow to move on to the
at any time
arrows F to change the data
arrows, the
arrow H.
Publicité
