HSM shredstar X15 Notice D'utilisation page 11

4 Operation
Warning!
Before switching the machine on,
make sure that you observe all safety
instructions.
• Insert the CD container provided
into the bracket on the inside of
the shredded material container.
Switching the paper shredder on
• Set mains switch at rear of paper shredder to
„I".
• Press the on/off button.
Note: You can increase the durability of your
shredder by removing all staples and paperclips
from the paper.
• Feed the paper into the centre
of the paper slot, but never insert
more than 15 sheets at the same
time.
 The light barrier starts the cutting unit auto-
matically. Therefore, with thin paper strips,
make sure the light barrier detects them.
 When the feed opening is clear of paper
again, the cutting device switches off.
Use the designated opening to
shred CDs and credit cards. Feed
the CDs in one by one.
• Empty the CD container at the latest after
shredding 10 CDs. To do this, unplug the
power plug and remove the cutting head.
The separate CD container is in the shred-
ded material container.
Note: You cannot use the two cutting units at
the same time. Destroy paper and CDs/credit
cards separately.
10/2013
Note: If the document shredder is not used for
30 minutes, it switches to energy saving mode.
All displays in the operator control panel will
go out. Pressing the on/off button activates
it again.
Swit ching paper shredder off
• Press the on/off button.
• Set mains switch at rear of paper shredder to
„0".
shredstar X15
english
11