NSK Ti-Max Z10L Mode D'emploi page 5

• Keep any debris or other foreign materials away
from inside the gear or the handpiece. Foreign
materials remaining inside may lead to
overheating, causing burn injuries or other
accidents.
• Ball bearings are wear items and may require
replacement. Be sure to inspect the handpiece
before use (Refer to "6 Checking the Handpiece
Before Each Use"). If abnormal vibration or noise
are found, the bearings or other internal parts
may be worn out or damaged. Damaged parts
may lead to handpiece overheating causing burn
injuries. If overheating is suspected, stop using
the handpiece immediately and contact your
Authorized NSK Dealer.
WARNING
• When operating the product always consider the safety of the
patient.
• Users are responsible for the operational control, maintenance
and continual inspection of this product.
• Prior to clinical use, inspect the handpiece. Check for
vibration, noise and overheating. If any abnormalities are
found, stop using the handpiece immediately and contact your
Authorized NSK Dealer. (Refer to "6 Checking the Handpiece
Before Each Use")
• Do not disassemble or alter the handpiece except as
recommended by NSK in this Operation Manual.
• Do not allow any impact on to the product. Do not drop the
product. Deformation may cause the handpiece to fail during
use.
• Operators and all others in the area must wear eye protection
and a mask when operating this handpiece.
CAUTION
3