Publicité
Les langues disponibles
Les langues disponibles
o If you use a sauce pan, the diameter of the pan may NOT exceed 26 cm. This means that the
largest circle on the glass plate of the appliance must be visible during use.
The appliance may be damaged if a larger pan is used.
The control panel
1. "Function" key: Use this key to select the required function. The function selected is shown by
the lights numbered 4. You can select setting the capacity (Power), the temperature (Temp)
and the time (Timer).
2. "ON/OFF" key: Use this key to switch the appliance on or to interrupt or reset the timer. When
you switch the appliance on, the most recently selected function will light up and the display will
go on. The red light next to the "ON/OF" key will go on as soon as the appliance is at mains
voltage and thus will not go off when you press the "ON/OFF" key.
3. "Arrow" keys: Use these keys for programming the capacity, temperature or time. The up arrow
increases the setting value and the down arrow reduces the setting value.
4. These lights indicate what mode you have selected by means of the "Function" key.
5. You can read the programmed value on this display. These are steps 1 through 10 for capacity
control, from 60°C to 240°C for temperature control and from 0 to 180 minutes for time settings.
Operation
Insert the plug in the wall socket; the red light next to the "ON/OFF" key will now go on.
x
Set the pan of your choice on the cooking surface, bearing the above-mentioned instructions in
x
mind.
ATTENTION! Make sure that the pans are covering the indicated zones at all times during use in
x
order to prevent the appliance from getting damaged.
ATTENTION! Do not leave your pan on the burner while empty as this may lead to damage to
x
your pans.
Switch the appliance on by pressing the "ON/OFF" key. If your pan is suitable for induction and
x
has a bottom diameter of 12 cm, at minimum, the appliance will go into operation. You will
recognize this from the fact that the fan will go on and the display will show a capacity position of
"5".
ATTENTION! If the appliance beeps after being switched on, the pan you are using is not suitable
x
for induction or the appliance is defective. In case of any doubt, always contact the supplier of
your pan!
Once the appliance is operating and the display indicates position "5", you can program the
x
appliance in one of the following two ways:
Publicité
