Fitting The Line Connections - Steinbach SPS 50-1T Notice Originale

Fitting the line connections

Some hoses, such as the pressure hose, are very stiff. Place them in the sun before use
so that the heat makes them more flexible.
Only hand-tighten all screw connections. Excessive tightening of the screw connections
damages gaskets and plastic components.
Use suitable pool hoses Ø 32 / 38 mm for the described connections. Other pool hoses (such as INTEX
with threaded connection) require additional adapters. For the matching adapters, visit our web shop at:
www.steinbach-group.com
To connect a swimming pool hose to the pump
or filter vessel, proceed as follows:
1. Guide a hose clamp over the hose.
2. Push the hose onto the hose connection.
3. Fix the hose clamp on the hose connection
using a Phillips screwdriver PH1.
The swimming pool hose is connected.
To connect a swimming pool hose to the hose
adapter of the pump or filter vessel, proceed
as follows:
1. Screw the hose adapter into the connection
thread.
2. Guide a hose clamp over the hose.
3. Push the hose onto the hose adapter.
4. Fix the hose clamp on the hose adapter
using a PH 1 Phillips screwdriver.
The swimming pool hose is connected to the hose
adapter.
To screw an INTEX swimming pool hose (not
included in the package contents) onto the
pump or filter vessel, proceed as follows:
1. Screw the adapter for INTEX pools or the
return line adapter for INTEX pools into the
connection thread.
2. Screw the hose onto the adapter.
The INTEX swimming pool hose is connected.
2
3
4
25