Lionelo Niles Manuel De L'utilisateur page 9

5.
Connect left and right arm to the frame (fig. 5).
6.
To disconnect arms from the frame, use a thin 4-mm tool (e.g. screwdriver),
press the interlock and pull the arms out (fig. 6).
7.
To fix the tray, insert it in the guide until locked in the handle (fig. 7).
8.
To fix the toy bar, insert the tips of the bar in the guides until locked in the
handle (fig. 8).
9.
LO-Niles allows adjusting leg rest in four positions. To change the backrest
inclination angle, press buttons on the sides (left and right side) of the seat
and set a suitable position (fig. 9, 10).
10. Before changing the backrest inclination angle, please take the child out of
the chair and lock arms. Next, press the backrest adjustment button (the
button is in the back of the rest in the upper area) and change backrest
inclination angle. 4 adjustment levels are available (fig. 11).
11. 6 chair heights are available. To change the chair height, press chair height
adjustment buttons located on side backrests and adjust the height (fig. 12).
12. 3 tray levels are available. To adjust the tray location, press buttons located at the
bottom of the tray and set a suitable distance between the tray and seat (fig. 13).
13. To activate a rocking feature, the lowest position of the seat must be adjusted.
Next release the protection by pressing the button in the center and lower
part of the rocking chair interlock (fig. 14).
Note: when the chair is rocking, you cannot change the seat height.
14. When the chair is rocking, you can choose two available positions of the
backrest (fig. 15).
15. When you have placed your child in the chair, please secure it with safety
belts. The length of belts can be adjusted by means of buckles (fig. 16).
16. To fold the base, press buttons on front connectors of the base and fold the
lower part by moving it to the center (fig. 17).
17. To unfold the base, press buttons on front connectors of the base and unfold
the lower part by moving it to the outside (fig. 18).
18. LO-Niles rocking chair can be provided with power supply in two ways.
a.
Supply through a supplied feeder cable (fig. 19).
b.
Supply through batteries AA (4 pieces) (fig. 20).
WARNING:
• To replace the batteries in the product, remove the battery compartment cover
and replace the batteries. Replace the cover.
‑ 9 ‑ EN