Furrion FGH4ZSA-SS Instructions Pour L'installation Et L'emploi page 11

Installation for Cooktop (with Furrion FSRI22LA Oven)
• Make the cut-out in the countertop per (Fig. B) When marking the cutout, ensure to
measure the cut out from the front of the cabinets to ensure the oven vent is in the
correct position
• Install the gas supply hose with 5/8-18UNF connection and shut off valve to the
back wall on the left hand side of the cooktop cut out.
• Two gas lines will be run for a Oven
+ Cooktop installation. Ensure to
connect the cooktop to the upper gas
connection.
• Ensure there is ventilation hole for air
circulation around the cooktop in the
cabinet.
• Ensure the countertop, surrounding
materials and bonding agents have
a temperature rating of no less than
193˚F (95˚C) to avoid deformation or
discolouration.
• Before fitting the cooktop to the cavity affix the roll of sealing putty (included in the
cooktop packaging) around the underside edge. Once putty is installed completely
around the underside, remove the putty protective film and then fit the cooktop in
cut out. Push down on the cooktop edges to seal and fix the appliance securely.
When installing a oven with a cooktop, ensure to measure the cooktop cut out
position from the front of the cabinet. The critical dimension is to make sure the
distance from the front of the cabinet to the rear of the countertop cut out is 18 3/8 " .
This is so the oven vent can be fitted together with the cooktop.
.
2
Installation
2
1
Fig. B
11