Klarstein SPO-17C Mode D'emploi page 12

EN
12
OPERATION
How to fill the shoe polish container
• Remove the container including the container holder
from the device.
• Proceed as follows: After unlocking the tab (see
sketch) and slightly swivelling it to the right, it will
come loose from the holder.
• Open the container and fill in shoe polish, preferably
colourless, to a maximum of ¾ of the filling volume.
• If you use a shoe polish of a different colour than the
last time, clean the inside of the container with water.
• Replace the container by first inserting the right side
and then snap the left side into place.
How to operate the shoe polisher
1. Make sure that the unit is stable on a flat surface.
2 Plug the plug into a wall outlet.
3. Make sure that the sole of your shoes is not dirty.
4. If necessary, clean your shoes before use with a soft, slightly damp cloth (to remove
the large residue on the top of your shoes) and wait until they are completely dry.
5. Use the hard cleaning brush for the first polishing. Press the on/off switch and lightly
press the shoe against the hard brush.
6. To polish, apply liquid shoe polish to the shoe by pressing the shoe against the
bottom of the shoe polish container once or twice (depending on the type of shoe
polish).
7. To polish your shoes, lightly press them against one of the two polishing brushes.
8. When your shoes have been polished, turn the machine off by pressing the on/off
switch.