Uline H-3107 Manuel D'utilisation page 4

6. Place the bottom (7) in the bottom lances of the
shelf adjustment strips. The flange with two holes
should face the front, and it should hang over the
sill. Bolt to the sill with two bolts and nuts.
(See Figure 5)
7
7. Set the unit upright and attach a coat rod bracket
(18) beneath the left side of the cabinet shelf by
inserting one bolt through the hole in the left edge
of the shelf. Secure with a nut. Attach the right
bracket in the same way. Slide the coat rod (17)
through holes in the brackets. (See Figure 6)
18
17
PAGE 4 OF 15
ASSEMBLY INSTRUCTIONS CONTINUED
Figure 5
Figure 6
8. Attach the doors (9) and (10) to the unit by placing
the door on the hinges, aligning the holes, and
using a hammer to tap the hinge pins (11) into
place with the side of a screwdriver. (See Figure 7)
NOTE: If having issues with doors aligning, it
may be due to cabinet not sitting level. Use
included nut driver to adjust leveling feet in
bottom front two corners. Nut driver should
insert through inside of cabinet down into feet
and adjust as needed.
9
10
11
0321 IH-3107
Figure 7