GOK CGV Instructions De Montage Et D'utilisation page 9

7. DESIGN
8. ADVANTAGES AND EQUIPMENT
Safety valve:
• self-closing pressure relief valve; when the set pressure is exceeded, the valve opens
automatically to relieve the pressure
• closes automatically when the pressure is below the set limit again
• the settings on the safety valve must not be changed
• there is a red plastic cap at the outlet of the safety valve
The red plastic cap must sit tightly on the outlet of the safety valve to prevent dirt
and water entering.
If the red plastic cap is missing, it is possible that the safety valve has been triggered.
9. CONNECTIONS
Inlet,
optional
Outlet
Trading name and dimensions
acc. to standard
GAZ thread connector
• with gasket
• G.3 = Thread M 16 x 1.5-rh
Primus thread connector
• G.32 = M14 x 1.5-rh
• gasket NBR
Trading name and dimensions
acc. to standard
Male thread connector
• gasket in the connector
• G.12 = W 21.8 x 1/14-lh small cylinder (KLF)
Male thread Shell
• G.2 = W 21,8 x 1/14 lh
Inlet connector on the gas
cylinder
Outlet connection
Safety valve with red plastic ca
Handwheel
Label gas type PROPAN
Arrow direction OPEN „+" or
CLOSED „–"
Installation notes
Tighten hand-tight.
Tighten hand-tight.
Installation notes
Tighten hand-tight.
Tighten hand-tight.
3