BH bikes Easy motion Manuel page 37

ATOM
4. Turning the Bicycle Lights and the Backlighting of the Display Panel On and Off.
Holding down the (-) button for 3 seconds will turn the backlighting of the display panel on and off.
The lights will also be switched on and off in those models equipped with a battery-powered light system.
At this moment, the lights on indicator will appear on the screen:
3 sec
5. Display of Secondary Information on the Screen.
The display panel screen allows the user to view various useful information. By pressing the POWER button,
the information on the screen will vary according to the selection made previously in the "Settings" menu:
1. Instantaneous power (W).
2. Trip power (W).
3. Instantaneous cadence (rpm).
4. Trip cadence (rpm).
5. Motor – User Power Balance (%).
6. Assistance Mode.
7. Instantaneous consumption.
8. Average trip speed (km/h).
9. Average total speed (km/h).
10. Trip distance (km).
11. Total distance (km).
12. Trip time (hh:mm).
13. Total time (hh:mm).
14. Range (only applies in BOOST mode).
NOTE
6. Battery Level Indicator.
The battery level indicator shows the estimated remaining battery capacity.
NOTE
The range is calculated based on the riding conditions during the last kilometre
and the remaining capacity of the battery.
In order to increase the life of the battery and prevent a full discharge
which may damage it, the assistance modes are limited based on the state
of charge of the battery:
• Battery with charge above 20%: All assistance modes are available.
• Battery with charge of 10-20%: 100%/BOOST assistance mode
is not available.
• Battery with charge of 5-10%: Only 30% (ECO) and 0% (NO ASSIST)
assistance modes are available.
• Battery with charge of 1-5%: No pedal assistance mode is available
(0%/NO ASSIST). Only the lights can be turned on.
USER MANUAL
EN
37