Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. Press
to start the operation of the device. The desired water will flow out from
water spout. Press
Danger of burns
► When you have stopped the dispensing, then the water which was already in the spout
will rinse. Be careful. Danger of burns.
If you want to dispense water again, repeat the steps above.
3.
► Without operation the device will switch to standby mode after 5 hours, then only the
start/stop
pressing the start/stop
► If device was not used for longer time there could be scale deposits despite water filter.
In this case let the device dispense amount for large cup with 100 °C.
► The device saves your settings for the amount of water for the cup sizes, this setting is
saved even if you pull the plug of the device.
► The ambient temperature changes everyday. This leads to different amounts of water. It
can vary up to +- 15%.
14.2.3
Water disposal from the drip tray
1. When the drip tray is full, grasp and stabilize the device by
one hand and use the other hand to lift up the drip tray slightly
to remove it.
2. Empty the drip tray and insert it into the original place. Make
sure it is properly inserted.
14.2.4
Replacing the waterfilter
1. Open the tank cover (A) and take out the filter box (B) with the
old waterfilter (C).
2. Soak the new waterfilter upright in water for 10 min.
again, when you want to stop the operation.
Please note
button is illuminated. You can reactivate the device at any time by
button.
36
Publicité
Table des Matières
