Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
15 Cleaning and Maintenance
This chapter provides you with important notices with regard to cleaning and maintaining the
device. Please observe the notices to prevent damages due to cleaning the device incorrectly
and to ensure trouble-free operation.
15.1 Safety information
Please observe the safety instructions, before cleaning your device
► Unplug the device when not in use and before any cleaning.
► Never immerse the device, cord or plug in water or other liquids and do not place in the
dishwasher.
► Do not use iron brush, abradant, kitchen cleaner, or sharp cleaning tool for cleaning.
15.2 Cleaning and descaling
Wipe the device with damp cloth.
Drainage stopper
The drainage stopper prevents water from flowing out of the device.
You can unscrew the stopper (3) with a screwdriver so that the dirty
water can drain off. Then put the stopper back into the opening.
Tighten it again so that it seals the drain.
► If you need to send the device to customer service, then first
remove the water from the device.
15.2.1
Cleaning and descaling function
When "Descale" is blinking in the display then the device needs to be descaled, please
proceed as follows:
Place device without drip tray and without water filter. Fill the watertank up to max marking.
Add a little bit of vinegar.
Place vessel below the spout which can collect whole content of watertank.
Press Clean-button. The display shows „50" as temperature. With
can select between 50, 80 und 100°C. We recommend 80°C. Start the process with
Start/Stop. The device dispenses whole content of watertank and will be cleaned and
descaled. Pour the water away. Rinse the watertank with fresh water after this.
15.3 Storage
If the device is not used frequently, unplug and clean it, then put back into the original
packing box to avoid that the electrical components from getting humidified or damaged.
Attention
Please note
Temp-button you
39
Publicité
Table des Matières
