Water Disposal From The Drip Tray; Replacing The Waterfilter; Error Code Lo Lack Of Water; Calibration - CASO DESIGN HW 660 Mode D'emploi

► The device has a memory function if the plug is still plugged in. The settings, that were
adjusted the last time, are still adjusted. The settings will be reset after unplugging.
► The ambient temperature changes everyday. This leads to different amounts of water. It
can vary up to +- 15%.
14.2.1

Water disposal from the drip tray

14.2.2

Replacing the waterfilter

1. Open the tank cover (A) and take out the
filter box (B) with the old waterfilter (C).
2. Soak the new waterfilter upright in water for
10 min.
3. Rinse the new waterfilter thoroughly under
running water.
4. Remove the old waterfilter and replace it
with the new waterfilter (see fig.).
Therefor take out the filter box, place the
new waterfilter and pull it down from the
bottom.
14.2.3

Error code Lo Lack of water

If the device stops to operate with a beeping sound and the display shows the error code Lo
Lack of water, it means that there is too little water or no water in the water tank. Please fill
in enough water into the water tank immediately.
14.2.1

Calibration

If you want to optimize the temperature or volume of water, then you can calibrate the device.
Fill the tank up to max marking.
Place vessel below the spout which can collect whole content of watertank.
Press and hold
"000" is shown press Start/Stop for confirmation. The device perfoms the calibration and
beeps once process is finished.
Please note
1. When the drip tray is full, grasp and stabilize the device by one
hand and use the other hand to lift up the drip tray slightly to remove it.
2. Empty the drip tray and insert it into the original place. Make sure
it is properly inserted.
Temp-button for 3 seconds until „CAL" is displayed. When volume
38