2-Thread Rolled Edge; Changing Thread - Singer S14-77 Manuel D'instruction

2–Thread Rolled Edge
For edging lightweight fabrics. It gives a nice finish on silky scarves, pillow ruffles and napkins. Thread the looper with a
decorative lightweight thread, such as 40 weight rayon for a beautiful satin edge (2-thread converter required).
Note: Not recommended for heavy weight fabrics.
Stitch/Fabric

Changing Thread

The following is an easy way to change threads:
1. Cut the thread in near the spool, behind the guides on the
telescopic thread stand.
2. Remove the thread spool and place the new thread on the
spool pin.
3. Tie the end of the new thread to the end of the old thread.
Cut the thread tails to 2-3cm (approx. 1") in length and
firmly pull both threads to test knot security.
4. Raise the presser foot.
5. First note tension dial settings and then turn the tension
dials down to "0".
6. Pull the threads through the machine one at a time until the
knots are in front of the needle. If the threads do not pull
easily, check for tangles on thread guides or looping under
thread stand.
7. Cut the thread behind the knot and thread the needle.
8. Return tension dials to previous settings.
18 – Sewing
English
Right
1.0 1~1.5 5~6
Right
1.0 1~1.5 5~6
Right
1.0 1~1.5
N/R
R Yes —
R Yes —
5 R Yes —
Thread Tension
5 — 4~6
5 — 4~6
5 — 4~6