of the scope. move upwards and hold to intensify dot until the desired
brightness is achieved, or downwards to dim. For fine adjustment, tip
very briefly into the direction desired until final setting desired.
the reticle is powered by a 3-volt lithium cell battery Cr2032. to
install a new battery, simply unscrew the battery cap on the left
side, press on one side of the battery to lift and remove, and install
the new battery flat side (+) up. it is advisable to remove the bat-
tery for long term storage (over a month). the cap containing the
spare battery can be mounted on both top and right side turret.
Note
Please inform yourself about local rules for
disposing of electronic products. Never dispose with
other household waste.
Parallax/Focus Adjustment
All scopes are tuned parallax free to 100 m. the 3-15×56 model
includes a parallax adjustment from 50 m to infinity. Parallax is the ap-
parent movement of the reticle in relation to the target when the eye
with the reference mark. if the distance is unknown, rotate the adjust-
ment knob until the target image is sharply focused.
When the scope is set parallax free for the distance you are viewing,
you should be able to move your eye side-to-side or up and down
without seeing the re ticle move appreciably in relation to the target.
Mounting the Scope
the rifle scope requires 30 mm rings. rail models work with standard
rail bases for "Z" or Zeiss rails. the rail cover included can be cut to
fill the remaining open space after mounting. SteiNer recommends
quality components and assignment of a qualified gunsmith to
ensure secure mounting, correct eye relief, complete field of vision and
maximum accuracy.
10
is not directly in line behind the
center of the scope. images from
different distances focus in front
of or behind the scope's reticle.
Parallax is more noticeable with
higher magnification scopes.
to use the parallax adjustment,
rotate the knob on the left side
of the turret housing until the
numeral corresponding to the
known target distance lines up
Care & Maintenance
Your Nighthunter Xtreme rifle scope is fully waterproof and fogproof
through N
Filling.
2
Objective and ocular lenses are protected from stubborn en-
vironmental substances such as oil, acids and salt water by SteiNer
Nano-Protection
. this surface is extremely water-repellent and is
®
easily cleaned. in the event that the lenses are subjected to dust, dirt
or mud, follow these steps:
Failure to remove grit before final cleaning is sure to damage lens
coatings. Coarse dirt/debris must be removed from the lens surface.
Position the scope so particles will fall away from the lens, and then
use a soft brush to gently whisk away the debris, while blowing on
the lens to dislodge the particles. For heavy dirt, like dried mud, use a
spray of clean water or lens cleaning fluid to remove the dirt. For quick
cleaning, please use the cleaning cloth integrated into the neoprene
protective cover.
Your SteiNer rifle scope will provide years of reliable performance
given reasonable care and treatment. All moving assemblies are
permanently lubricated. Only occasional cleaning of the outside of the
scope and the exterior lenses is required.
Never disassemble your scope. Disassembly by anyone other than our
factory will void the warranty. if you have any problems with your
SteiNer rifle scope, return it to your dealer to send it to the factory
for repair.
Warranty
By purchasing a SteiNer rifle scope you put your trust in
precision, ruggedness and quality of our products. in return we
guarantee a long lasting function of your rife scope and give you a
10 year warranty starting at day of purchase. excluded are wear parts
like batteries or rubber parts. Warranty for electronics is limited to
2 years. Please keep the warranty-pass, found on the last page, in a
safe spot. in case of a warranty claim, fill out the pass completely and
send it together with the receipt and the rife scope back to us.
For further information, please visit our website: www.steiner.de
11