Publicité
Les langues disponibles
Les langues disponibles
2. USAGE
Check the water level and top up if
necessary. When filling the tank, you
must always fill the basin and as the
water passes through the filter you
can regularly top it up.
4
The light will change to solid red and
there will be a double beep to
indicate the end of the first stage.
You will need to make up your feed
within 2 minutes.
8
Remove the milk storage lid and
replace your bottle onto the bottle
stand.
12
For your child's safety always check
food temperature before feeding by
testing on a sensitive part of your
skin.
Before each use, you must ensure that your water tank is above the minimum fill mark.
Water to fill the unit must come from the cold faucet.
1
Select the bottle size you require on
the setting dial (4fl oz – 11fl oz).
5
Carefully remove the bottle from
the stand and measure the correct
number of formula scoops into the
bottle.
9
Press the start/stop button again.
The red light will go out and the
green light will flash. If this button is
not pressed within 2 minutes of the
hot water being dispensed a long
beep will sound. If the alarm sounds
you should discard the feed and
repeat the process from step 1.
13
Your bottle is now ready to serve.
Make sure you discard any unwanted
feed as per the formula manufactur-
ers recommendation.
2
Position your sterilized bottle under
the dispenser. Adjust bottle stand if
necessary (bottle neck should sit close
to the outlet).
6
Screw the sterilized milk storage lid
on to the bottle and ensure that the
lid is tight. Be careful when handling
hot liquid.
10
Wait whilst the remainder of water
is dispensed. Once completed there
will be a double beep and the green
light will change to solid.
HOW TO STOP THE
PERFECT PREP™ MACHINE
If at any point you need to stop the perfect prep™ machine you
can do so by pressing the start/stop button. The pump may
continue to run for a few seconds and the green light will
illuminate to show that the process has ended. Should you have to
stop the perfect prep™ machine please discard of any feed.
3
Press the start/stop button.
A red light will flash and a volume
of hot water is dispensed into your
bottle.
7
Shake well until the formula powder
has dissolved.
11
Always check that the amount
dispensed is consistent with the size
of feed you have selected on the dial.
Add the sterilized nipple, screw ring
and hood and shake.
Publicité
