Tommee Tippee closer to nature perfect prep Mode D'emploi page 3

1. SET UP AND
CLEANING
1
Place a container (should have a
capacity of about 2 pints) under the
unit dispenser outlet to capture the
water used to clean the system.
5
Press the cleaning mode button and
hold for 2 seconds. The cleaning
mode light will illuminate.
9a
*Handling the filter cartridge by the top only:
• Remove the filter cartridge from packaging
• Remove sticker from the top of filter
• Fill a bowl with potable (drinking) water
• Fully submerge the cartridge in the water
• Gently agitate until the bubbles cease
12
Press the start/stop button. A red
light will flash.
Before first use you need to run a cleaning cycle – which should take approximately 10 minutes. You should clean your
unit as part of the set up and again whenever you replace your filter. For hygiene and safety
reasons you should always clean your unit if it has been unused or in storage for longer than 2 weeks.
2
Plug in the unit, the tank empty
warning light will illuminate.
6
Wait whilst the boiled water is
emptied from the tank, through the
dispenser, into the container you
placed under the outlet in step 1.
9b
Remove the water hopper and
fit the filter* Replace in the
water tank.
13
The appliance will dispense an
amount of hot water.
3
With the water basin in place (but
not the filter) fill the container with
about 2 pints of freshly boiled water
-
7
The tank empty warning light will
illuminate once the water has
flushed through the system.
10
Fill the basin with cold water.
14
Press the start/stop button again.
A green light will flash and an
amount of water will be dispensed
to finish the cycle.
4
Wait for the tank empty warning
light to go out. The water tank hot
light will illuminate.
8
Discard the water captured in your
container and replace it under the
dispenser.
11
Wait for the tank empty warning
light to go out.
15
Discard dispensed water.
YOUR SYSTEM IS NOW
READY TO USE.