Publicité
Les langues disponibles
Les langues disponibles
CONNECTION AND OPERATION
-
The device is designed for indoor use. Do not use outdoors. Place the appliance on a flat surface in a
ventilated location.
-
Remove the stopper from the liquid fog reservoir, fill it with approved fog liquid and replace the stopper.
Using products other than those specified may cause damage to the device.
-
Connect the device to the power supply.
-
Wait 3 to 5 minutes for the machine to warm up before operating it.
-
Press the button on the remote control until the desired flow rate is reached. If the machine becomes too
hot, it will automatically shut off.
-
If the machine is not going to be used for a while, we recommend that you disconnect it from the mains.
NOTE: always fill the reservoir with liquid fog when the machine is disconnected from the mains.
SECURITY RECOMMENDATIONS
-
Do not use this equipment outdoors. It should be placed in a well-ventilated place with at least 30 cm
clearance on all sides to allow air flow and prevent the machine from overheating. It should be protected
from sources of heat and fluids as well. If you suspect that water may have seeped through the slots
in the machine's chassis, immediately disconnect the machine from the mains and contact qualified
personnel for inspection before operating it again.
-
Always place the fog machine with the cap on the reservoir facing upwards.
-
Never cover the machine's ventilation slots.
-
Do not leave the fog machine in operation without liquid in the reservoir, as this could cause damage to
the pump as well as to the heating circuit.
-
Do not transport this device with liquid in the reservoir.
-
Always close the plugs on the fog machine container and reservoir immediately after refilling the reservoir
to prevent damage from prolonged air exposure.
-
Do not add flammable liquids of any kind (oil, gas, perfume) to the fog liquid.
-
Keep out of the reach of children.
-
Do not point directly at people or animals.
-
In case of inhalation or ingestion of the fog liquid, contact Emergency Services immediately.
-
Do not aim at fires or other sources of heat.
-
CAUTION with the emission of fog. This unit can reach extremely high temperatures during operation
and may cause burns or accidental fires if flammable materials are nearby.
CLEANING THE FOG MACHINE
After about 40 hours of use, we recommend cleaning the device with a solution composed of 80% distilled
water and 20% white vinegar. This will prevent residue from accumulating in the device's heating element.
-
Always disconnect the machine from the mains and allow it to cool down completely (to room temperature)
before cleaning.
-
Pour the cleaning solution into the reservoir.
-
Switch on the device and wait for it to warm up.
-
Operate the device in a well-ventilated place until the reservoir is empty.
-
When the cleaning process is complete, refill the reservoir with fog liquid.
- 3 -
EN
Publicité
