Sharp HT-SB602 Mode D'emploi page 19

System connections (continued)
„ IR (Infrared) transmitter connection
If the TV's remote sensor is blocked by the sound bar, use the IR transmitter to relay the signal to the TV.
1. Connect the IR transmitter to IR out terminal to allow the TV's remote signal to pass through.
2. Place the infrared emitter near TV's remote sensor (refer the operation manual of the TV for the location of the
sensor ).
Point the TV's remote control at the sound bar remote sensor and operate the TV.
You may need to move the IR transmitter until the TV operates correctly.
Then secure the IR transmitter onto the sound bar using the double sided tape provided.
Note:
z Do not use the IR transmitter if the TV's remote control sensor is not blocked by the sound bar.
TV
remote
control
„ HDMI Connection
Caution:
Turn off all other equipment before making this connection.
The illustration below shows the flows of the signals.
Audio and Video signal
TV
1. Method 1
This connection is for HDMI TV with ARC (Audio Return Channel).
To HDMI (TV ARC) input terminal
To HDMI OUT (TV ARC) output terminal
All manuals and user guides at all-guides.com
Rear view
Double sided tape
(Peel off the double sided
tape separator before fixing)
Sound Bar
TV
Sound Bar
E-8
TV
TV remote sensor
Infrared emitter
DVD/Blu-ray
Digital tuner
DVD, Blu-ray disc
player or similar
To HDMI output
terminal
To HDMI input terminal