Publicité
Les langues disponibles
Les langues disponibles
Referring to Fig 2:
1.
Turn the blending jug upside down and place the seal over the rim of the jug.
2.
Carefully lower the blades into the blending jug.
3.
Screw the locking ring onto the blending jug.
4.
Place the blending jug onto the motor unit with the lug
5. Use the blending jug handle to turn the jug clockwise as far as it will go. This will tighten the locking ring. To loosen
the locking ring, place the blending jug onto the motor unit with the lug
anticlockwise.
1.
Place the blending jug onto the motor unit. The blending jug handle can be on the left or the right. Make sure that the
lugs on the blending jug are resting aginst the stops on the rim of the motor unit.
2.
Add the ingredients to the blending jug and fit the lid and stopper. Fit the stopper by inserting it into the hole in the lid
and then twisting it a quarter turn clockwise.
Turn the speed control to position I, II or III as required. For more control over blending, operate the speed control in
3.
short bursts.
Tips
•
Ingredients can be added through the hole in the lid by removing the stopper. The stopper is graduated and can be
used as a measure for small quantities.
•
Always support the blending jug with your hand while blending (Fig. 3).
•
Allow hot liquids to cool before processing. Place a folded dishcloth over the top of the blending jug and place your
hand over the cloth during processing (Fig. 3).
•
Don't overfill the blending jug.
Make sure the unit is switched off and unplugged from the mains supply socket before cleaning. The blades are
very sharp, take care when washing them. Do not immerse the motor unit, mains lead or plug in water or any other
liquid.
Cleaning
•
Remove the blade assembly from the blending jug and wash the jug, blade assembly, seal and locking ring in warm,
soapy water. Rinse and dry thoroughly.
•
Wash the lid and stopper in warm, soapy water. Rinse and dry thoroughly.
•
Wipe down the motor base using a damp cloth or sponge and dry thoroughly. Make sure you only use a mild detergent
solution.
Quick cleaning method
1.
Half fill the blender with warm water and add a small amount of detergent. Fit the lid and stopper.
2.
Set the speed control to II for 10-20 seconds.
3.
Remove the blending jug and rinse it under running water.
ASSEMBLING
USING YOUR BLENDER
CARE AND CLEANING
in front of the stop
X
Y
behind the stop
X
5
.
and turn the jug
Y
Publicité
