Troubleshooting - Kenmore AllergenSeal DU2055 Manuel D'entretien Et D'utilisation

Aspirateur vertical sans sac équipé de brosse à rouleau hair eliminator™
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Review this table to find do-it-yourself solutions for minor performance problems. Any
service needed, other than maintenance described in this Use & Care Guide, should be
performed by a qualified service agent.
WARNING
Disconnect electrical supply before performing maintenance to the vacuum cleaner.
Failure to do so could result in electrical shock or personal injury.
PROBLEM
Unplugged at wall outlet.
The On/Off switch is not pressed
to start the vacuum cleaner.
Vacuum cleaner
Defective wall outlet.
will not run.
The vacuum body is overheated.
The motor is damaged.
The hose or attachments are not
installed correctly.
Dust cup is not installed correctly. Check dust cup for correct installation and
Full or clogged dust cup.
There is a clog in the flexible hose
or connection hose of the vacuum
cleaner.
Poor job of dirt
Suction control is in open position. Adjust the suction control to increase suction.
pick-up.
The foam filter, felt filter or HEPA
media exhaust filter needs to be
cleaned or replaced.
The flexible hose is worn.
The connection hose is worn.

TROUBLESHOOTING

POSSIBLE CAUSE
Plug in firmly, press the On/Off switch to "I"
or "II" position.
Press the On/Off switch to "I" or "II"
position.
Check with a good appliance or lamp. Be
sure the power cord plug is fully plugged
into a good wall outlet.
Unplug the power cord and let the vacuum
cool down for 50 minutes.
Call 1-877-531-7321 (US) / 1-844-608-3081
(CA) for assistance.
Check the hose and attachments for correct
installation and ensure they are snapped
firmly in place.
ensure it is snapped firmly in place.
Empty the dust cup (page 17).
Check and remove all clogs. Follow
instructions on page 21.
Follow instructions on page 15.
Clean or replace the foam filter, felt filter or
HEPA media exhaust filter. Follow the foam
filter and felt filter cleaning or HEPA media
exhaust filter cleaning instructions on page 19
or 20.
Replace the hose assembly. To purchase parts,
call 1-877-531-7321 (US) / 1-844-608-3081
(CA).
Call 1-877-531-7321 (US) / 1-844-608-3081
(CA) for assistance.
- 22 -
SOLUTION

Publicité

Table des Matières
loading

Table des Matières