english
Proper hand position requires one hand on the main
handle or on the top of the unit as shown in Figures
9A and 9B.
Switching On and Off (Fig. 1)
To switch the tool on, set the on/off switch (A) to
position I.
To switch the tool off, set the on/off switch to
position O.
Sanding
1. Start with the coarsest grit size.
2. As the tool produces small scratch marks in all
directions, it is not necessary to sand with the
grain.
3. Check your work at short intervals.
4. Always switch off the tool when work is finished
and before unplugging.
MAINTENANCE
Your D
WALT power tool has been designed to
e
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
24
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
• After the tool is used in metal sanding
applications without dustbag, clean the tool
using low-pressure air.
Optional Accessories
WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D
WALT, recommended
e
accessories should be used with this
product.
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
Separate collection. Products and
batteries marked with this symbol must
not be disposed of with normal
household waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for
raw materials. Please recycle electrical products
and batteries according to local provisions. Further
information is available at www.2helpU.com.
WALT, have
e