Operation; Selecting The Mode; Pump Operation - Steinbach Comfort 50 Notice Originale

Masquer les pouces Voir aussi pour Comfort 50:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 46
4. Check the filter system and the connections for leaks.
5. Backflush the system (see section "Backflushing").

Operation

Risk of death when operating the water treatment system during bathing.
Hair or clothing might get sucked into the suction openings of the pool and in extreme cases
trap persons under water and prevent them from surfacing again.
- Never operate water treatment system devices while persons are in the pool.
- Prevent any access to the pool for as long as water treatment system devices are in use.
A damaged device or damaged accessories may cause injuries.
- Check the device and the accessories (see section "Testing").
Clarifying agents in the pool water can lead to clumping of the Active Balls and severely
impair their cleaning effect.
- Do not use any clarifying agents for water treatment when using Active Balls as filter
medium.

Selecting the mode

Switch the pump
off by pulling the power plug.
10
Press and hold down the valve lever
position and let go.

Pump operation

1. Make sure that all hoses and pipes are correctly connected and that the water level in the pool is at
least 1 to 2" (2.5 to 5 cm) above the opening of the suction line.
2. Check the valve setting of your filter system before you activate the pump.
3. Connect the pump's power plug to the power supply.
The running time display blinks (if a battery is inserted, the last selected running time is displayed).
4. Press the timer button
5. Switch on the pump
The pump starts running at this time and deactivates itself automatically once the selected running
time has expired. The timer activates the pump every day at the same time for the same running
time (once every 24 hours).
The pump is running.
6. Check the pump for unusual noises.
If there is air in the system, bleed it again.
7. Press the ON/OFF button on the timer
Manual stopping the pump deactivates the timer.
The pump is switched off.
36
WARNING!
CAUTION!
Risk of injury!
NOTICE!
on the valve head
35
several times until the LED of the desired running time is lit.
37
by pressing the ON/OFF button on the timer
10
to manually stop the pump operation.
37
. Turn the valve lever to the desired
1
.
37

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Comfort 75

Table des Matières