Light Kit Assembly - Craftmade Waterfront WAT52 Instructions D'installation

9. Light Kit Assembly.

Remove 1 screw from motor plate (on underside
of motor) and partially loosen the other 2
screws. Align slotted holes in middle of fitter
plate with loosened screws in motor plate,
allowing molex connections from motor
housing to come through hole in middle of fitter
plate. Twist fitter plate to lock. Re-insert screw
that was just removed and tighten all 3 screws
securely.
Remove 1 screw from post, located in the center,
on underside of fitter plate and partially loosen
the other 2 screws.
Connect WHITE wire from motor housing to
WHITE wire from LED light kit. Connect BLACK
(or BLUE) wire from motor housing to BLACK
wire from LED light kit. Be sure molex
connections snap together securely.
Arrange wires carefully within LED light kit. Align
slotted holes in LED light kit with loosened
screws from post located on fitter plate. Twist
the LED light kit to lock. Re-insert screw that was
previously removed and securely tighten all 3
screws. [Refer to diagram 2.]
Partially loosen 3 thumbscrews on outer edge of
LED light kit. Raise glass shade to LED light kit,
pushing up gently until lip on glass shade fits
securely inside LED light kit. Re-tighten
thumbscrews. [Refer to diagram 3.]
WARNING: Do NOT overtighten thumbscrews as
glass may crack or break.
Make sure glass shade is secure by pulling down
GENTLY on glass shade.
Remove 4 screws from post located on
underside of fitter plate. Align holes in top of
glass shade support with holes on post. Secure
glass shade support with 4 screws that were just
removed. [Refer to diagram 3.]
fitter plate
diagram 1
fitter plate
diagram 2
thumb
screw
screw
glass shade
diagram 3
page 9
motor
housing
motor plate
molex connections
screw
screw
motor housing
molex
connections
LED light kit
screw
LED light kit
shade support
screw