Craftmade Waterfront WAT52 Instructions D'installation page 6

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5. Fan Assembly. (cont.)
Thread safety cable and wires through hanging
ball; then slide hanging ball over downrod--the
top of the downrod should be noted as having a
set screw hole; use this hole when setting the set
screw. Insert stop pin into top of downrod and
raise hanging ball. Be sure stop pin aligns with
slots on the inside of the hanging ball. Tighten
set screw securely. [Refer to diagram 4.] Lower
yoke cover to motor housing.
WARNING: Failure to tighten set screw
completely could result in the fan becoming
loose and possibly falling.
Remove electrical tape from electrical wiring and
thread each of the wires through a different hole
in the weatherproof hanging ball cover. Thread
the safety cable with the green (ground) wire.
Pull weatherproof hanging ball cover down
securely over hanging ball (on downrod). [Refer
to diagram 4.]
With the hanging bracket secured to the outlet box
and able to support the fan, you are now ready to
hang your fan. Grab the fan firmly with two hands.
Slide downrod through opening in hanging
bracket and let hanging ball rest on the hanging
bracket. Turn the hanging ball slot until it lines up
with the hanging bracket tab. [Refer to diagram 5.]
WARNING: Failure to align slot in hanging ball with
tab in hanging bracket may result in serious injury
or death.
Tip: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you
once you are set on the ladder.
Find a secure attachment point (wood ceiling joist
highly recommended) and secure safety cable. It
will be necessary to use a heavy duty wood screw,
washer and lock washer (not supplied) with the
safety cable loop. If necessary, adjust the loop at the
end of the safety cable. The loop at the end of the
safety cable should just fit over the threads on the
wood screw. Test safety cable by pulling on loose end
with pliers. If the safety cable slips, the loop must be
adjusted tighter. Extra cable slack can be left in
ceiling area.
electrical wiring
stop pin
hanging ball
diagram 4
wood
ceiling
joist
diagram 5
page 6
safety cable
weatherproof
hanging
ball cover
set screw hole
set screw
canopy
safety cable loop
wood screw
and washer
safety cable
hanging bracket tab
hanging ball slot

Publicité

Table des Matières
loading

Table des Matières