Parking Shoe; The Planing Process; Chamfering Edges; Using The Guide Fence - Parkside PEH 30 B2 Instructions D'utilisation Et Consignes De Sécurité

socket.
Planing debris removal port (right /
left selectable):
Release the planing debris removal port 3
□
by turning it into the "Lock-off" position
along the direction of the arrow.
Pull the planing debris removal port 3 out
□
of the device.
The planing debris removal port 3 can be
□
set to face left or right in the planer.
Push the planing debris removal port 3
□
into the device.
Lock the planing debris removal port
□
3 by turning it into the "Lock" position 3 by turning it into the "Lock" position
3
along the direction of the arrow.
External vacuum extraction:
If necessary fit the vacuum cleaner adapter
when using a dust extraction system, e.g.
15
a workshop dust extraction system.
The vacuum cleaner / dust extraction device
used must be suitable for the material being
planed.
Connection:
Place the vacuum cleaner adapter
□
firmly on to the planing debris removal
port .
3
Push the hose of a suitable dust extraction
□
device approved for that purpose (e.g.
a workshop vacuum cleaner) on to the
planing debris removal port
vacuum cleaner adapter
Removal:
Pull the hose of the dust extraction device
□
off the planing debris removal port
off the vacuum cleaner adapter
Pull off the vacuum cleaner adapter
□
if fitted.
Parking shoe (see Figs. B / C)
●
The parking shoe
device down without the risk of damaging
the workpiece.
When planing, the parking shoe
3
up and exposes the rear part of the sole
3
●
3
■
3
□
□
□
□
□
●
15
The V-grooves
the device to be used for simple chamfering
of workpiece edges.
□
or the
3
□
.
15
●
or
3
.
15
,
□
15
□
□
Preparing for use
allows you to lay the
16

The planing process

CAUTION! DANGER OF KICKBACK!
Always switch on the device before
placing it against the workpiece.
Set the required cutting depth.
Switch on the device.
Always place the front part of the sole
down first on to the workpiece.
Guide the device with even forward
movement over the surface being planed.
Move the device forward at a slow rate
and ensure that the contact pressure acts
evenly on the sole
9
too great a rate results in a poorer surface
quality and can lead to blocking of the
planing debris removal port.
Chamfering edges (see Fig. H)
in the front sole
10
Use the V-groove most appropriate to your
desired chamfer width.
Place the planer with the V-groove
the workpiece edge and guide the planer
along the edge.

Using the guide fence

(see Fig. I)
Attach the guide fence
with the fixing screw
Release the fixing nut
guide at the desired distance.
Retighten the fixing nut
swings
16
.
9
9
. Moving forward at
allow
9
on
10
to the device
6
.
7
8 and set the
8 .
GB / IE / NI 59