EdilKamin ECOIDRO Installation, Usage Et Maintenance page 25

Hopper capacity
Overall efficiency
Water efficiency
Overall available power
Power available for water heating
Time between refuellings (min/max)
Fuel consumption (min/max)
Minimum draught
Maximum pressure
Weight including packaging (steel/ceramic)
Heatable room *
Diameter combustion product flue (female)
* The heatable room dimensions are calculated assuming the use of pellets of the type described in the note, and home insulation
which complies with Italian law No. 10/91, and subsequent changes together with an expected heat output of 35 Kcal/m³ per
hour.
A LOT DEPENDS ON THE EFFICIENCY OF THE HEAT EMITTING UNITS (radiators).
ELECTRICAL SPECIFICATIONS
Power supply
On/off switch
Average power consumption
Average power consumption during ignition
Remote control frequency (optional extra)
Protection on mains power supply *
Electronic circuit board protection
BACKUP
LITHIUM LITHIUM
BATTERY
SMOKE EXTRACTION
MOTOR
90 90 120 120
SCREW FEEDER
MOTOR
TECHNICAL AND HEATING SPECIFICATIONS
230Vac +/- 10% 50 Hz
yes
150
400
infrared
Fuse 2A, 250 Vac 5x20
Fuse 2A, 250 Vac 5x20
SMOKE RPM
WATER OUTLET
TEMPERATURE
DETECTOR MANDATA ACQUA MANDATA ACQUA
230 Vac POWER
SECOND
SUPPLY 50Hz +/- 10%
FUSE
INGNITING ELEMENT
SECOND FUSE
CIRCOLATORE CIRCOLATORE
WATER CIRCULATION
PUMP ACQUA ACQUA
SERIAL PORT
On the RS232 serial
(clean voltage clean con-
tact on the pins)
port with the appropriate
W
cable (code 621240), the Dealer may install an optio-
W
nal device for remote on/off operation, for example a
dialler or room thermostat.
BACKUP BATTERY
A backup battery is found on the control board (3-Volt
CR 2032 battery). Its malfunction is indicated with the
following messages: (not considered a defect but due
to normal wear-and-tear): ERROR RTC RD. For more
detailed information, please contact the DEALER who
has performed the first 1st ignition.
OPTIONAL EXTRAS
DIALLER (code 281900)
GSM dialler for pellet stoves, to turn on/off remotely
with a mobile phone text message.
FUSE
* two fuses are inserted on the socket behind the
stove, fitted with a switch one is functional and
the other is spare.
27 kg
90,1 %
86,1 %
11,3 kW
10 kW
10/33 houres
0,8/2,7 kg/h
12 Pa
2 bar
170/204 kg
295 m 3
8 cm
pin 6
pin 2
* *
25