Operation Instructions - Arrow MiniPlus Gun Mode D'emploi

IMPORTANT When using electric tools, basic safety precautions should always
be followed to reduce the risk of fire, electrical shock and personal injury.
STEP 1
Insert 5/16" (8mm) diameter glue stick through tunnel at back of glue gun.
STEP 2
MINIPLUS - TWO MODES OF OPERATION:
A. For corded use –
I Corded glue gun use without base stand - Plug power cord into bottom of glue
gun handle and plug the other end of the power cord into the electrical outlet.
Press the glue gun on/off switch to the ON position (I) (DOWN), work light
at the front end of the glue gun nozzle will illuminate. Preheat three (3) to five
(5) minutes. Fold wire stand down for placement when glue gun is idle and back
for use.
II Corded glue gun use connected to base stand - Align the end of the glue gun
handle into the custom fitted prongs of the base stand and slide glue gun into
the base stand as far as possible. Plug power cord into the back of the glue gun
base stand and unfold the base stand with the silicone pad positioned below the
glue gun nozzle. Plug the other end of the power cord into the electrical outlet.
Press the glue gun on/off switch to the ON position (I) (DOWN), work light
will illuminate and preheat three (3) to five (5) minutes. After hot glue reaches
working temperature, fold glue gun base at joint, positioning the silicone pad
under the base stand. This will allow you to use the glue gun connected to the
base stand plugged into the electrical outlet for continuous use.
6
OPERATING INSTRUCTIONS
STEP 1
STEP 2A
I
CORDED USE
WITHOUT
BASE
STEP 2A
II
CORDED USE WITH BASE