Head Section Positioning; Kidney Elevator Instructions - Nuvo B2AV1000-1 Manuel

5.2.4

Head Section Positioning

Head section is manually adjustable 90° maximum up or down from the Back section.
1. To adjust the Head section upward, lift
the Head section by hand.
2. To adjust the Head section downward,
locate the spring-loaded bar pull and
pull it to unlock the Head section to
lower it to a desired angle and release
the bar pull. Move the Head section
slightly until ratchet mechanism locks
it into position.
5.2.5

Kidney Elevator Instructions

The kidney elevator is manually adjustable up to 4.7in
(120mm) from the tabletop.
1. Locate the ratchet wrench (#12, Figure 3-2) under the
right side of Back section, fold down and bring out the
handle.
2. Adjust the lever to the right for the upward direction, and
then use the wrench to bring up the kidney elevator.
3. Adjust the lever to the left for the downward direction,
and then use the wrench to bring down the kidney
elevator.
5.2.6 Cassette Channels
There are Cassette Channels beneath the tabletop where the radiograph can be taken. Just slide
in the x-ray film cassette (14" wide only).
Figure 5-6:
Figure 5-7:
5-20
B2AV1000 Series Surgical Table
IM-B2AV1000-E01