Using Override System For Table Positioning - Nuvo B2AV1000-1 Manuel

Display/Code
23
24
25
26
27
28
29
30
31
*i.t.: initial tests performed in the beginning of turning on the hand pendant.

5.2.2 Using Override System for Table Positioning

PINCHING HAZARD: Extreme tabletop articulation creates pinch points. Before
operating the table, review illustrations in Figures 5-1, PINCH POINTS.
PINCHING AND TIPPING HAZARD: If user is not completely familiar with the controls
for patient positioning and table operation, patient could sustain injury.
EXPLOSION HAZARD: Do not use this table with flammable anesthetics.
UNEXPECTED TABLE MOVEMENT HAZARD When the table moves by itself as you
enable the override system, disable it right away and call a technician for service.
(B2AV1000S(K)(P) only)
UNEXPECTED TABLE MOVEMENT HAZARD: If the surgical table begins to move on
its own when the override control toggle switch is put in either the up or down position,
immediately put the switch back in the middle position, discontinue use of the table, and
call a technician for service. (for B2AV1000/B2AV1000K)
UNEXPECTED TABLE MOVEMENT HAZARD: When using any control, please
Symptom
Not Used
Using Slide button of hand pendant on
Non-slide table
Not Used
Not Used
Voltage too high (i.t.)*
Voltage too low (i.t.)*
Upon switching on, Service LED lights
and emits bi-bi-bi sound (i.t.)*
Not Used
Wrong DIP Switch setting
(B2AV1000(K)) (i.t.)*
WARNING!
Wrong Setting
Wrong Setting
Did not disable Override
System
5-13
B2AV1000 Series Surgical Table
IM-B2AV1000-E01
Cause