FTE Maximal eXtreme HD compact Guide D'installation Rapide page 21

Follow next steps for the correct installation of this receiver.
SteP 1: outPut Video ConfiGurAtion
In order to correctly visualise the reception signal on TV, you must configure the format and mode of
the video output.
- Video output: In order to get a correct visualization of the image we recommend:
1. In case you make the connection to your Tv by the means of "Tv scart" outputs, select "SD" video
output
2. In case you make the connection to your Tv by the means of "HDMI" output, select "HD" video
output.
- Video resolution. You will be able to select among the following formats:
1.In case SD video output is selected, you will be able to select AUTO, PAL or NTSC format.
2.In case HD video output is selected, you will be able to select among the following formats: AUTO,
TV, 480I, 480P, 576I, 576P, 720P_50, 720P_60, 1080I_25, 1080I_30, 1080P_50, 1080P_60,
1080P_25, 1080P_30 or 1080P_24.
SteP 2: ConneCtionS
The coaxial cable, with satellite signal, must be connected to the "IF IN" connector. The HDMI or
SCART connectors must be connected to the TV set.
Connect the LAN port to your Network socket or directly to your internet router using a cable Cat 6* in
order to use the internet menu options.
* The cable Cat 6 is not included with this receiver. You will need to purchase it separately.
Depending on the type of installation, the receiver should be connected and configured following next
examples.
example 1 – Basic System
QuiCk inStAllAtion Guide
QuiCk inStAllAtion Guide
PAG. 3
example 2 – DISEqC switches