Dyna-Glo DGP552SSP Mode D'emploi page 17

ASSEMBLY INSTRUCTIONS
21. Open the left door assembly (Q) and the right
door assembly (K), insert the hose/regulator
assembly into the cart assembly through the
hole on the cart right side panel assembly (L).
Place LP gas cylinder (sold separately) into the
nesting hole located on the cart bottom shelf
(A1). Rotate the LP gas cylinder until the hose/
regulator coupling aligns with the threaded
valve of the cylinder. Hand tighten the hose/
regulator coupling to the threaded valve of the
LP gas cylinder.
Tighten the tank screw clockwise
rear of the cart until the LP gas cylinder is
secured in place inside the nesting hole of the
cart bottom shelf (A1).
Fully Assembled
Front View
Rear View
21
in the
17
Q
A1
LP Gas
Cylinder
L
K
Tank
Screw