Remote Control; Maintainance; Troubleshooting - RHINO BLX Manuel D'utilisation

Connect the terminal clamps securely. Otherwise you may have
trouble using the motor.
The battery should always be kept in a well-ventilated location.
The motor runs with all standard 12V batteries. We recommend
using a special low charge marine battery or a LiFeP04 battery
for optimum performance.
CAUTION: Any changes to the factory
installed battery connections will void the
warranty. The electric pole clips must be
connected securely, otherwise there may
be disruption in the electric current.

2.8 Remote control

Please see the GPS Owner's Manual for information on the
functions of the remote control.
BLX 65 BMR GPS
12 V
Black (–)
B
Red (+)
A

3. MAINTAINANCE

After use, carefully rinse the motor unit with running water and
wipe the control unit with a damp cloth.
On a monthly basis, inspect the electrical connections for signs
of corrosion. Replace defective terminals or cables immediately
to prevent possible overheating.
After approx. 100 hours of service, the graphite brushes of the
driving unit should be replaced by Zebco Customer Service.
Be sure to choose a well-ventilated and dry location when
storing the motor for longer periods.
Do not leave the motor outdoors during the winter, as this could
cause damage to the drive unit and the control unit.

3.1 Troubleshooting

Loss of performance
• Propeller action might be „sti ". Check to see if line or weeds
have got caught in the propeller.
• Check the battery charge status. Check the battery cells.
• Check the terminals on the battery cable.
Power consumption is too high
• Check for „sti " propeller action
• Corrosion or short circuit in top motor housing
• Check the battery cells
Motor sounds too loud and/or shakes
• Check t and condition of the propeller; you may have to re t
the propeller, turning it by 180°.
• Bent shaft. Detach propeller and run motor at low speed,
listening for abnormal sounds from shaft.
• If shaft is bent, return motor to Zebco for repair.
• Turn propeller by hand; return motor to Zebco if action is sti .
Remote control non functional
• change battery
• synchronize with motor again
For all other problems not listed above, please contact
your dealer or Zebco Customer Service.
5