Installing The Monitor; Connections - Avidsen LUTA 2+ Mode D'emploi

Colour video interCom

2 - INSTALLING THE MONITOR

Attach the wall mount to the wall using the screws and wall plugs suited to the support (the screws and plugs
supplied are suitable for solid walls).
After connecting the monitor (refer to the "connections" paragraph), fit the monitor onto its support.
ø6 mm

3 - CONNECTIONS

• Do not increase the number of insulating screw joints or connectors on the connecting wire between the
doorplate and the monitor
• Keep the connecting wire between the doorplate and the monitor more than 50 cm away from any
electromagnetic interference (230 V cable, WiFi device, microwave ovens, etc.)
• You can connect and use the electric door release (not provided) with your doorplate, with or
without mechanical memory.
Between the monitor and the doorplate (100 m maximum)
To ensure good audio and video quality, it is advised to not use more than 100 m of cable between the
intercom and the doorplate. Connect the wires as follows (incorrect wiring can damage the doorplate).
The cable's length determines which cable section is to be used:
Cable length
0 to 50 m
50 m to 100 m
C - iNSTALLATiON
Section to use
0.75 mm2
1.5 mm2
en
9